Optical Endstop Sensor Optoelectronic Limit Switch Module W/Cable Optical End Stop Switch For 3D Printer Accessories Ramps 1.4

Description: 100 new and high quality! Type: optical endstop sensor Module size: about 3.3*1.1cm/1.3*0.43in Cable length: 51cm/20.08in Color: as shown The kit includes: 1) One optical switch TCST2103 photointerrupter, 2) One 3-pin 51 cm long connection cable Tips: Under normal circumstances, the system needs to be equipped with at least 3 optical switches. Advantages: 1. The use of optical transmission principle design, no loss, no noise, longer service life, more than one hundred thousand times. 2. The optical switch is a reliable stop/switch solution that can be used for any type of 3D printer/CNC/3D tool. 3. The use of light control limit optical switch RAMPS can improve the accuracy of the whole system. The sensing edge of this switch is very clear, making the motion control of the device more precise. 4. The response time of the optically controlled limit optical switch is very fast, which can almost reach the instant response to the input change. 5. Since the switch is controlled by optical signals, there is no mechanical contact wear, so its service life is very long. Note: 1.Please allow 1-3cm differs due to manual measurement. 2.Due to the different monitor and light effect, the actual color may be a slightly different from the picture color. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.