100 Pcs Replacement Steel Needles For Flooring Wall Tile Leveling System 1.5Mm

Features: There is hardly any crackless, flat surface. It reduces the need for grinding and polishing. Prevent tiles from moving during solidification. Wear-resistant, recyclable. Easy to use in DIY operation. Balance tiles in the same horizontal position. Improve the installation speed of tile. Reduce the fatigue/pressure of installers.

Specifications: Name:Steel Needles for Tile Leveling System Material:stainless steel Size:Length of steel needle:32mm Thickness of steel needle:about 1.5mm Type:100pcs Steel Needles

Use Tips: Lay the first tile, leaving more than 2mm (with cross gaskets). Close to tile. Insert T-pins along the gap between tiles. Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles. Adjust the lid with a hand/special wrench until the two tiles are on the same level. After leveling, about 5-6 hours, before the cement/binder is completely dry, rotate the lid in reverse and take out the 180 degree T needle until the word is removed.

Avoid not removing the T-tile leveling system: 1. Ceramic tile gaskets are 2mm or more (cross gaskets are recommended) 2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned. 3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried. Package Include:100pcs

Note: 1.Please allow 0.1cm error due to manual measurement. 2.The color of the product will be a little different from the color of the picture because of the difference between the light and the discriminator. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.