Features:
Designed with voltmeter, voltmeter error is + 0.1V, measuring range is 5V 35V.
Touch button switch changes measurement of input or output voltage, and there is indicator light shows which voltage is measured.
Input and output have screw terminals for convenient connection even with no soldering iron, and keep solder pad for soldering connection.
The maximum output current can be up to 4A; it is recommended that the working current in about 2A, and add heat sink please if more than 2A.
Using the internal oscillation frequency of 400kHz, belong to second generation of the switch voltage regulator, low consumption, high efficiency.
Widely used for storage battery, power transformers, DIY adjustable regulated power supply, industrial equipment, 9 to 12V, 12V to 18V, 18V to 24V, etc.
Specifications:
Input Voltage: 4.5V 32V
Output Voltage: 5V 35V (adjustable)
Max. Output Current: 4A
Efficiency: <92percent
Output Ripple: <30mV
Switch Frequency: 400kHz
Operating Temperature: 40 celsius +85 celsius
Size: Approx. 66 x 36 x 14mm 2.59 x 1.41 x 0.55
Instruction:
1. For the first time powering on, the default display
is input voltage, and the input indicator IN lights up.Press the button,
then it displays output voltage, and the output indicator OUT lights
up.The last setting will be saved, even if power off and restart.
2.
Input output voltage measurement error calibration:Press and hold button
switch for more than 4 seconds then release to enter voltage
measurement error calibration function, indicator IN lights up(input
voltage calibration), and display flickeringly shows calibration value
(default is 0.0). Press button to change this value (range of 0.5V to
0.5V)After adjustment of the input voltage calibration value, press and
hold button for more than 2 second then release to enter the output
voltage error calibration function, indicator OUT lights up (output
voltage calibration), and display calibration value. Adjustment method
is the same as the input adjustment. After adjustment, press and hold
button for more than 2 seconds then release to save set value and return
normal voltage displaying.The calibration value is enabled immediately
and saved when power failure.(This function can provide higher accuracy)
3.
Turn off the voltmeter:Press and hold switch for more than 1 second
while less than 4 seconds then release to turn off voltmeter.Voltmeter
will be turned on if press switch after it is turned off.
Note:
1. If input voltage is lower than 4.5V, the voltmeter will not work and display.
2. Input voltage must be at least 1V higher than output voltage.
3. When power is over 20W, a heat sink is recommended to enhance heat dissipation.
4.
If output voltage is always equals to input voltage and cannot be
adjusted,turn potentiometer more than 10 circles counterclockwise
please, then voltage can be adjusted normally.
5.
Package Includes:
1 x Boost Converter Module
.
