Yamazaki Smart Projector 10cm W X D X 11cm Includes Drywall Tweezers and Wood Product Number 5898 Wall-Mounted Rack, Black, Approx. 23.8cm H, Screws,

*Please be aware that if the seller or shipping source is outside of Japan, there is a risk that the product may be a replica. Product size: Approx. W10 x D23.8 x H11cm. Internal dimensions: Mounting section: Approx. W5 x D23.5 x H1.5cm. Fixing screw mounting section: Approx. W1.3 x D19.5cm. Load capacity: Approx. 3kg (Static load capacity assuming zero impact). Quality display: Body: Steel (powder coated) 材してます。 English: Accessories: 1 each of projector fixing screws (1/4 inch x 11.3 mm, 1/4 inch x 18 mm), 2 washers, 1 L-shaped part, 4 plasterboard tweezers, 4 wood screws, 3 silicone seals, hex wrench. Note: Assembly required. Suitable walls: When using plasterboard pins: plasterboard with wallpaper, fabric wallpaper, vinyl wallpaper, etc., thin plywood. When using wood screws: pillars, wooden walls, printed plywood (where there is a horizontal bevel on the back). *Please read the compatible projectors carefully before purchasing to confirm that your projector is compatible. *Please read your projector's instruction manual carefully to determine the installation position and distance. *Compatible projectors: The fixing screw on the bottom must be a single-hole type that is compatible with 1/4 inch screws. (Do not use a set screw conversion adapter, etc.) *If installing horizontally, please check that your projector supports horizontal keystone correction. *The projector must weigh less than 3 kg. Compatible sizes: There must be no protrusions or other obstacles on the bottom of the projector that are more than 1 cm in height. The screw fixing part on the bottom of the projector must be less than 1 cm in height and less than 1.2 cm in width. If there are terminal connection cords etc. on the back: A gap of more than 10 cm is required (the screw fixing part on the bottom must be less than 11.5 cm from the back of the projector) If there are no terminal connection cords etc. on the back: The screw fixing part on the bottom must be within 2.5 to 21.5 cm from the back of the projector.