Oxygen Sensor O2 Lambda Sensor Extender Spacer for Decat & Hydrogen M18

Feature: 1. Stainless steel material. 2. Polished front surfaces enabling perfect tightening. 3. Threads made with dedicated tool, perfect accuracy and repeatability. 4. Made by professional manufacturer, quality assurance. 5. Simple installation. Just unscrew the lambda oxygen sensor, screw in the emulator in its place and then screw in the oxygen sensor. 6. Stainless steel material. Internal and external thread M18 x 1.5. Outer contour: the hexagonal TURN KEY 27. 7. Exhaust gas inlet hole 3 mm. In extreme situations narrowing of the inlet hole prevents motor failure (driving at high speed). 8. Stainless steel material. Made by professional manufacturer, quality assurance. 9. Internal and external thread M18 x 1.5. Outer contour: the hexagonal TURN KEY 27. 10. Polished front surfaces enabling perfect tightening. Threads made with dedicated tool, perfect accuracy and repeatability. Specification: In vehicles with EURO 3 and higher vehicle emissions standards the second lambda oxygen sensor emulator is located after the catalytic converter. It plays a diagnostics role. If it detects any irregularities on the basis of the data from the engine control unit it displays an error on the dashboard (a popular "CHECK ENGINE") and the engine can switch into emergency mode (depending on the make of car). It is often manifested by big power drop. These problems arise in the event of removal of the catalyst, its low efficiency, or its replacement with jet pump. In such situations, it becomes necessary to mount THE SECOND LAMBDA OXYGEN SENSOR EXTENDER. The catalyst can effectively reduce the power output of 2 to 3percent , and the maximum power speed of up to 5percent . Its removal and the use of emulator is the easiest way to low cost raise of power. The emulator can also help in case of problems with the LPG installation, which due to the detection of very rich mixture will display the CHECK ENGINE on the dashboard. Features: Iron zinc plating Internal and external thread M18 x 1.5. Outer contour: the hexagonal TURN KEY 27. Exhaust gas inlet hole 3 mm. In extreme situations narrowing of the inlet hole prevents motor failure (driving at high speed). Polished front surfaces enabling perfect tightening. Threads made with dedicated tool, perfect accuracy and repeatability. Made by professional manufacturer, quality assurance. Simple installation. Just unscrew the lambda oxygen sensor, screw in the emulator in its place and then screw in the oxygen sensor. Specifications: Material:Iron zinc plating Color: silver Size: check on our pictures Package Size: 10 * 5 * 1cm 4 * 2 * 0.4in Package Weight: 109g 3.9oz Package List: 1 * Oxygen Sensor Extender Spacer Package List: 1 * Oxygen Sensor Extender Spacer