R&G Easy Grip Tank Grips EVO Black Centre Tank Pads In Black - Design B (RG-EVOCENTREPADBBL)

Eazi-Grip™ Tank Pads offer two unique surfaces—"Evo" and "Pro"—that provide a high level of grip, and are available in four designs.

The "Evo" series features a pronounced hemispherical traction dome that allows you to feel the grip through the leather.

Installation Notes: To prevent the adhesive from hardening, application should be performed in an outside temperature of at least 18°C ​​(68°F), preferably above 20°C (68°F). This may be difficult unless you're using a garage heater. Use a heat gun (or a household hair dryer) to warm the area to be applied, then apply it again to further soak the adhesive. However, overheating can cause melting or discoloration, so be careful not to apply the heat gun directly to the surface or expose it to air for long periods of time without moving the pad.

Installation: Allow at least 24 hours for the adhesive to stabilize. (This is especially true in winter, when temperatures are low.) Using the pad before it is fully bonded may result in peeling or slippage. Reapplying the pad will weaken the adhesive and make it more likely to peel. Please work carefully and with extreme caution. Color: Black Eazi-Grip tank pads offer two unique surfaces—"Evo" and "Pro"—that provide a high level of grip. Available in four designs, the "Evo" series features a pronounced hemispherical traction dome that lets you feel the grip through the leather. [Installation Notes] To prevent the adhesive from hardening, install the pad in an area with an outside temperature of at least 18°C ​​(68°F), preferably above 20°C (68°F). This may be difficult unless you're using a heater in a garage. Use a heat gun (household hair dryer) to warm the area to be applied, then apply the adhesive. Reheating the adhesive from above will help improve adhesion to the vehicle. Note: The adhesive requires at least 24 hours for the adhesive to stabilize. (This may take longer in winter, especially in cold temperatures.) Using the pad before it is fully bonded may result in peeling or shifting.