1/2/4/6 Teeth Stainless Steel Leather Stitching Punching and Chop 3mm Teeth Width Suitable for Belt Wallet DIY Leather Making

1/2/4/6 teeth stainless steel leather stitching, punching and chop 3mm teeth width suitable for belt wallet DIY leather makingOne tooth and two teeth are often used for punching in turning positions or for right-angle single holes. When using, they must be matched with a soft punching plate to prevent abrasion of the edge.Four teeth are used for direct punching and have a wide range of applicationsSix teeth are used for accelerating drilling in the entire row of long straight linesHand-polished, sharp edge is super sharpSharp cut cuts allow easy penetration of leatherNotes:1. When punching, the flat cut needs to be perpendicular to the leather surface to prevent it from tilting and breaking the cutting teeth.2. Do not use a hammer/hammer when knocking and cutting, you need a rubber hammer or a special installation hammer! The iron hammer has a relatively large impact on flat cuts and is easier to break.3. When using flat chop to punch holes, please pad flat chop protection cushions under the skin to protect the cutting tip.