1 Piece Stepping Motor Linear Screw Shaft Rod Block 13 Teeth Plastic Gear Diy Camera Monitor 15Mm 2-Phase 4-Wire Stepper Motor

Description Brand new miniature 15mm two-phase four wire stepper motor. Its output shaft is a worm gear, which drives the gears to rotate and forms a worm gear reduction transmission relationship, with a reduction ratio of 1:9.5. The stepping angle of the motor itself is 18 degrees, which is two pulses to rotate 360 degrees. Now, after deceleration, the gear needs 190 pulse signals to rotate 360 degrees. We have not yet figured out the specific usage method of this small deceleration component. Buyers should feel that it can be used before placing an order. We cannot provide technical support, please understand. Note: This motor is a two-phase four wire stepper motor, which requires an external stepper driver and pulse signal to operate normally. It cannot work if directly connected to a DC power supply. Specification: 1. Motor lead length: 60mm 2. Motor type: 2-phase 4-wire stepper motor 3. Motor phase resistance: about 9.6 ohms 4. 5V short circuit current: 0.49A 5. Gear rario: 1:9.5 6. Material: Metal 7. Tips: The working mode of this stepper motor is driven by the driver to rotate the gear. The outer diameter of the gear is 7.6 mm, with 13 teeth and a gear module of 0.5 module. It requires 190 pulse signals and the plastic gear rotates 360 degrees. Package List: 1* Stepper Motor

Note: 1. The color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. Please refer to the actual product received. 2. Please allow slight manual measurement deviation for the data. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.