Chlortix pool tablets
Tablets with bactericidal and fungicidal, properties that dissolve quickly in water - immediate disinfection of water in swimming pools. Tablets should be placed in a skimmer or floating dispenser, because if dropped directly into the water they may discolor the bottom of the pool.
Directions for use:
When filling the pool with drinking quality water, adjust the pH to 6.9-7.2. With the circulation pump turned on to ensure constant and even mixing of the water, use 60 g of Chlortix T per 10 m3 of water. The bactericidal effect is achieved after 24 hours.
It is recommended to repeat the procedure once a week. A large number of people using the pool and strong sunlight accelerate the consumption of chlorine in the pool water. If such a situation occurs, it is recommended to add 30 g of Chlortix T per 10 m3 of water after 3 days
Parameters:
Number of tablets: 50
tablet weight: 20g
Product form: tablets
Intended use: For disinfection of swimming pool water
The most common problems with pool water.
1. Milky or cloudy water
Incorrect pH: adjust pH between 7.0 and 7.6. Perform shock treatment.
Insufficient chlorine level: perform shock or flocculation treatment, wash the filter again, run filtration for 24 hours.
Insufficient filtration: increase filtering duration. At high temperatures, at least 10-12 hours per day.
2. Green water:
Appearance of algae: perform shock chlorination, wash and rinse the filter, flocculate and use anti-algae preparation.
3. Limescale deposits:
Incorrect pH: adjust pH between 7.0 and 7.6.
Increased hardness: add water softener.
4. Brown, red, black water:
Presence of iron or magnesium: adjust the pH between 7.0 and 7.6, perform shock chlorination, liquid flocculation, stop filtering for 12 hours, then suction out the sediment from the bottom.
5. Chlorine smell, eye and skin irritation
Incorrect pH: adjust the pH between 7.0 and 7.6.
Presence of chloramines: perform shock chlorination.
6. Difficulty maintaining chlorine or pH level:
Insufficient chlorination in case of frequent use: shock chlorination and balance the pH between 7.0 and 7.6.
7. pH too high:
Too high alkalinity: check the water pH frequently, add pH minus.
8. pH too low:
Too low alkalinity: check the water pH frequently, add pH plus.
Crystalline water in 5 steps.
1. pH Correction
Before dosing chlorine, check and adjust the water's pH. This is important because if the water's pH is poor, the chlorine may not work or may be too aggressive. The ideal pH for pool water should be between 7.0 and 7.6.
2. Shock Chlorination
After setting up the pool or changing the water, shock chlorination should be performed. After dosing, the biocidal effects are almost immediate. The best product for this is Shock Chlorination.
3. Disinfection
To maintain a sufficient amount of active chlorine in the water, use slow-dissolving chlorine tablets.
4. Algae Control
To prevent the appearance of algae and unpleasant slippery sides and bottom, use Alga Off.
5. Coagulation
To maintain crystalline water, use liquid coagulant. This agent, through coagulation, breaks down small impurities into larger clusters that can be filtered by the pump.
The biocidal product should be used with caution. Before each use, read the label and product information.
1000g of product contains 990g of the active substance - symclosene CAS: 87-90-1, EC: 201-782-8 (900g active chlorine content).
Permit number: 6245/15.
No-delivery refund
